News
Featured Hotrunner at K 2013Braunform will be running a 96 cavity mold in an Engel Machine with a 5 sec cycle time producing a needle holder. This is all accomplished with the help of an edge gate Heitec hot runner system
News
New methods for producing energy savings when using Hot Runner Systems The benefits offered by hot runner systems for the injection molding industry such as material savings and cycle time reduction are widely known. However, in the past very little attention was paid...
News
Case Study Bearing Cage 0.028 gram shot The Plastechnik AG, which is based in 3178 Bösingen, Switzerland, is specialized in the production of technically sophisticated plastic parts and the design and manufacturing of injection moulds. HEITEC Heisskanaltechnik GmbH...
News
HEITEC Star-Line Crown 12-Cav HEITEC introduces a new version of the 12-Cav Star-Line Crown 01.072.64.12.140 based on the proven Star-Line hot runner nozzles. This multiple nozzle for side gating of plastic articles can inject up to 12 cavities using a single hot...
News
Heitec offers a solution to dead spots in the melt channels of hot-runner manifolds. The melt channels are milled into the plates, providing a smooth channel for the plastic to flow through. This eliminates any sharp turns or any hang up points (dead spots) in the...
News
May 22 at 7:45am until May 23 at 1:45pm Jack Burke Research and Economic Development Center, Penn State Behrend 4701 College Drive, Erie, PA 16563 Paul Boettger, Technoject Machinery, NEW ADVANCEMENTS IN APPLYING HOT RUNNER TECHNOLOGIES EFFECTIVELY TO CHALLENGING...